As an alternative, you can display the values without frames. This option can be activated in the Results Navigator under "Values on Surfaces" → "Settings" → "Transparent." You can also deactivate the red point in "Display properties" as well.
As an alternative, you can display the values without frames. This option can be activated in the Results Navigator under "Values on Surfaces" → "Settings" → "Transparent." You can also deactivate the red point in "Display properties" as well.
Mr. Rehm is responsible for developing products for timber structures, and he provides technical support for customers.
In the Concrete Design add-on, you have the option to define an existing vertically oriented punching shear reinforcement. This is then taken into account in the punching shear design.
In RFEM, the oriented strand board (OSB) material is available for the USA and Canada. The material parameters are taken from the "Panel Design Specification manual".
In the ultimate configuration of the steel joint design, you have the option to modify the limit plastic strain for welds.
The "Base Plate" component allows you to design base plate connections with cast-in anchors. In this case, plates, welds, anchorages, and steel-concrete interaction are analyzed.