In this webinar, you will learn how to consider construction stages in RFEM 6.
Time Schedule:
00:00 Introduction
04:20 Example 1: Continuous beam creep CSA + TDA
31:35 Example 2: Building CSA + TDA
42:35 Example 3: Phase sections in CSA
In this webinar, you will learn how to consider construction stages in RFEM 6.
Time Schedule:
00:00 Introduction
04:20 Example 1: Continuous beam creep CSA + TDA
31:35 Example 2: Building CSA + TDA
42:35 Example 3: Phase sections in CSA
The Concrete Design add-on for RFEM allows you to perform the fire design of reinforced concrete walls and slabs according to the simplified table method (EN 1992‑1‑2, Section 5.4.2 and Table 5.8 and 5.9).
In the Concrete Design add-on, you have the option to define an existing vertically oriented punching shear reinforcement. This is then taken into account in the punching shear design.
In the ultimate configuration of the steel joint design, you have the option to modify the limit plastic strain for welds.
The "Base Plate" component allows you to design base plate connections with cast-in anchors. In this case, plates, welds, anchorages, and steel-concrete interaction are analyzed.